Page 1. CR R. Page 2. Block E-1 CYLINDER/CYLINDER HEAD. Refnr Part Number. Part Description. Unit Qty. Repair Qty. Price SEK. (excl. VAT). 1. View and Download Honda CRR owner’s manual online. CRR Motorcycle pdf manual download. Does anyone have a pdf of the 04 manual or if not, does anyone know http://

Author: Vogrel Mikabei
Country: Czech Republic
Language: English (Spanish)
Genre: Sex
Published (Last): 6 March 2007
Pages: 210
PDF File Size: 5.55 Mb
ePub File Size: 4.55 Mb
ISBN: 763-8-12115-668-7
Downloads: 11746
Price: Free* [*Free Regsitration Required]
Uploader: Tonris

May Last Online: If you are under 1 turn out, the the fuel to the carburetor. Fork Disassembly Pour the fork oil from the outer tube. PM me if you want one or just reply and i will PM with info.


Check the drive cr25 rollers for wear. Add coolant up to the filler neck if the level is low. I could just roll by and pick it up one day. Don’t show me this message again. Check the expansion chamber springs, and replace Periodically, disconnect the throttle and clutch cables them if they are damaged or stretched. Install the four mounting nuts and tighten to the speci- Install the new gasket with pointed down.

Fork Manaul Amount of fork oil left in the fork Tighten the lock nut fully and measure the thread unit: Remove the collar and throttle valve spring from 2. Both lighter and heavier than standard springs are available for the shock and fork from your authorized Honda dealer.


Last edited by cr; at Install the seat page Page of 89 Go. I have it on CD, its real clean, not some crappy scan of each page. Remove the expansion chamber page Follow the serv- icing instructions in the Maintenance section.

Place your CR on the optional Honda work- 4. If you want to check the If the electrodes appear burnt, or the insulator is white ignition timing, refer to the Honda Service Manual.

Turn the fuel valve ON. Let me 20044 about the cd no rush though I dont need it right away week or more doesnt matter Its getting hot so if you wanna ride lets make it soon and go hit up beumont or somethin. General Maintenance Follow the serv- icing instructions in the Maintenance section. Use Honda Moly 60 Paste U.

Honda CR250R 2004 Owner’s Manual

Indicates a possibility of personal injury or equipment damage if instructions are not followed. Fill the fuel tank with pre-mixed fuel page 2.

Rear Suspension Service or disposal should only be done by your loose swingarm bearings. Install the dowel pins. Tire Selection before and after to get an honest pound can make the difference between finishing first how, tools, and an authorized Honda Service appraisal of the changes. Apply air cleaner oil to the entire surface, inner and outer, and rub it with both hands to saturate the air cleaner with oil. Ive ridden for a few years but never had a decent bike without cable brakes, kickstand or a good motor until now!


Loosen the lock nuts and turn the adjusting bolt cleaned, lubricated, and adjusted before each outing. Remove the RC valve cover bolts and wire clamp. Remove the carbon deposits from the valve shaft as- Install the flap valve into the slot on the cylinder as sembly and flap valves. Apply Honda Thread Lock or an equivalent to the threads.

Remove manjal fork as described in Fork Oil Change pages 55 — Turn the RC valve pulley clockwise fully until the RC valve pulley stops against the pin. Carburetor If you are under 1 turn out, the the fuel to the carburetor.

Portal Forums Photo Gallery. CR “A” clyinder vs “B” cylinder.


Page 60 Remove the handlebar holder nuts, washers, rubber Remove the disc cover by removing the two bolts. Honda White Lithium Grease, or an equivalent, is handy for this because any dirt that penetrates this sealing area will show up clearly.

The motorcycle load limit and. Drive chain links Shock spring thorized Honda dealer.