siders BS , the draft ISO standard , and AGMA. Since this review was written, AGMA introduced. AGMAB88, although this new. Find the most up-to-date version of AGMA at Engineering AGMA , Geometry Factors for Determining the Pitting Resistance and Bending AGMA , AGMA Standard for Rating the Pitting Resistance and .
|Published (Last):||19 August 2009|
|PDF File Size:||4.41 Mb|
|ePub File Size:||6.69 Mb|
|Price:||Free* [*Free Regsitration Required]|
Pitting Resistance Geometry Factor, I A mathematical procedure is described to determine the Geometry Factor, Ifor internal and external gear agam of spur, conventional helical and low axial contact ratio, LACR, helical designs.
Quantity must be a positive whole number. Basic principles, introduction and general influence factors ISO It was commonly used in vehicle gearing design.
Foreword This Information Sheet, AGMA B89, was prepared to assist designers making preliminary design studies, and to present data that might prove useful for those designers without access to computer programs.
Geometrical definitions ISO Calculation of tooth bending strength ISBN: Calculation of surface durability pitting ISO However, agreement could not be reached on the total content. Due to the number of requests for this paper, it was decided to publish the data in the form of an Information Sheet which became AGMA Suggestions for improvement of this standard will be welcome.
While the method is presented in the context of ISO and calculation of the load capacity of spur and helical gears, it is equally applicable to other types of gear stress.
AGMA – PDF Free Download
For dated references, only the edition cited applies. The tables for geometry factors contained in this Information Sheet do not cover all tooth forms, pressure angles, and pinion and gear modifications, and are not applicable to 218.10 gear designs. These values are then used in conjunction with the rating procedures described in AGMA B88, Fundamental Rating Factors and Calculation Methods for Involute Spur and Helical Gear Teeth, for evaluating various spur and helical gear designs produced using a generating process.
However, information is also contained for determining geometry agms for other conditions and applications.
The procedure is valid for generated root fillets, which are produced by both rack and pinion type tools. Because an analytical method for calculating the Bending Strength Geometry Factor, 2218.01is now available, Discounted member price: Quantity must be a positive whole number.
It is hoped that sufficient geometry factor data is included to be of help to the majority of gear designers. Calculation of service life under variable loadwhich was published in August SCOPE This part of ISO specifies the information and standardized conditions necessary for the calculation of the service life or safety factors for a required life of gears subject to variable loading.
It was approved as an American National Standard on May 20, Miner to assess the effects of cumulative fatigue damage under repeated and variable intensity loads.
The calculation procedure for I was simplified, but the end result is mathematically identical. The method was developed for aircraft part design and tested for aluminum alloys by Miner, but was subsequently verified for steel by agmx. For undated references, the latest edition of the referenced document including any amendments applies.