APL 1A Low Dropout Fast Response Positive Adjustable Regulator and Fixed V, V and V. Features. Guaranteed Output Voltage Accuracy within. APLVC-TU 1A Low Dropout Fast Response Positive Regulator Fixed V and V 1A, Details, datasheet, quote on part number: APLVC-TU. APLUC-TU from Anpec Electronics Corp.. Find the PDF Datasheet, Specifications and Distributor Information.
|Published (Last):||10 August 2004|
|PDF File Size:||2.66 Mb|
|ePub File Size:||13.36 Mb|
|Price:||Free* [*Free Regsitration Required]|
On-chip thermal limiting provides. In order to obtain datsaheet dropout voltage and faster transient response, which is critical for low voltage applications, the APL has been optimized. The APL output capacitor selection is dependent upon the ESR equivalent series resistance of the output capacitor to maintain stability.
Результаты поиска для APL1117-AH
For fixed voltage devices the top of R1 is internally. The data sheet speci- fication for load regulation is measured at the output pin of the device. By plac- ing a resistor between these two terminals, a con- stant Current is caused to flow through R1 and down through R2 to set the overall output voltage. If R1 were con- nected to the load, RP is multiplied by the divider ratio, the effective resistance between the regulator and the load would be: For fixed voltage devices R1 and R2 are included in the device.
On-chip thermal limiting provides protection against any combination of overload that would create excessive junction temperatures. This will improve transient response as well as pro. Current limit is trimmed to ensure specified output current and controlled short-circuit current. ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and. Dropout voltage is guar- anteed at a maximum of 1.
Best load regulation is obtained. Tantalum, or aluminum electrolytic capacitors can be used for bypassing. Home – IC Supply – Link. X C should be approximately.
The data sheet speci. The device is available in an adjustable version and fixed output voltages of 1. The output available volt.
Dropout voltage is guar. Basic Adjustable Regulator ues will improve ripple rejection by bypassing the in- put to the regulator.
APL datasheet, APL datasheets, manuals for APL electornic semiconductor part
Best load regulation is obtained when the top of the resistor divider R1 is tied di- rectly to the output pin of the device, not to the load. The APL is a low dropout three-terminal adjustable. The device is available. For fixed voltage devices the top of R1 is internally connected to the output, and the ground pin can be connected to low side of the load.
X C should be approximately datashfet to R1 at ripple frequency ANPEC reserves the right to appl1117 changes to improve reliability or manufacturability without notice, and advise customers to obtain satasheet latest version of relevant information to verify before placing orders. Simplified Application Circuits 1. Load Regulation When the adjustable regulator is used. A low-ESR solid tantalum capacitor works extremely well and provides good transient re- sponse and stability over temperature.
APL Datasheet(PDF) – Anpec Electronics Coropration
The output available volt- age range of an adjustable version is from 1. Load regula- tion will be limited by the resistance of the wire con- datasehet the regulator to the load.
This will improve transient response as well as pro- mote stability. When the adjustable regulator is used. Proper capacitor selection is important to ensure proper operation. Normally this current is chosen to be the specified minimum load current of 10mA.