Designation: D – Standard Test Method for ASTM Standards: 2 1 This test method is under the jurisdiction of ASTM Committee D18 on Soil and. Page 1. ASTM D Unconfined Compressive Strength. Page 2. Page 3. Sample Type: Remarks: Unconfined Compressive Strength. (ASTM D – 06). Borehole No.: . Jan TCPL/SimonetteLL GrandePrairie.
|Published (Last):||9 December 2004|
|PDF File Size:||7.72 Mb|
|ePub File Size:||11.78 Mb|
|Price:||Free* [*Free Regsitration Required]|
Unconfined Compression Test UCT is a simple laboratory testing method to assess the mechanical properties of rocks and fine-grained soils. Unconfined Compression Test Geotechdata.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Can you edit this page?
This standard does not purport to address all of the safety problems, if any, associated with its use.
There was a problem providing the content you requested
Link to Active This link will always route to the current Active version of the standard. It is beyond the scope of this test method to consider significant digits used in analysis methods for engineering design.
The primary purpose of the Unconfined Compression Test is to quickly determine a measure of the unconfined compressive strength of rocks or fine-grained soils that possess sufficient cohesion to permit testing in the unconfined state.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Pricing information and quote request on Geotechgate.
Copyright – Geotechdata.
As for the results, the axial stress is usually plotted versus the axial strain. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to commensurate with these considerations.
Free quote for buying Unconfined Compression Test equipment: Principles of Unconfined Compression Test, Chap 7.
ASTM D – 06 Standard Test Method for Unconfined Compressive Strength of Cohesive Soil
The values stated in inch-pound units are approximate. Active view current version of standard. In the unconfined compression test, the sample si placed in the loading machine between the lower and upper plates. The determination of the unconsolidated, undrained strength of cohesive soils with lateral confinement is covered by Test Method D In addition, they are representative of the significant digits that should generally be retained. Note 1 The determination of the unconsolidated, undrained strength of cohesive soils with lateral confinement is covered by Test Method D The sample is then removed for measurement of the water content.
Dry and crumbly soils, fissured or varved materials, silts, peats, and sands cannot be tested with this method d216 obtain valid unconfined compression strength values. Send us an email to editor geotechdata. In general, The UCT can be conducted on rock samples or on undisturbed, reconstituted or compacted cohesive soil sample. Detailed description of Unconfined Compression Test, Chap 7.
This measure is then used to calculate the unconsolidated undrained shear strength of the clay under unconfined conditions.