Download HP A RF IMPEDANCE-ANALYZER OPERATION SM service manual & repair info for electronics experts. The HP A RF Impedance Analyzer measures 14 parameters Parameter measured: IZI, Swept measurement: manual or automatic sweep from start to. Agilent A Test Fixture. Operation and Service Manual. Third Edition. Agilent Part No. February Printed in Japan.

Author: Yojin Shaktidal
Country: Tajikistan
Language: English (Spanish)
Genre: Music
Published (Last): 27 June 2015
Pages: 431
PDF File Size: 15.46 Mb
ePub File Size: 3.4 Mb
ISBN: 446-8-73036-842-3
Downloads: 13925
Price: Free* [*Free Regsitration Required]
Uploader: Shajas

Agilent / HP 4191A RF Impedance Analyzer

Has anyone done anything on interfacing with the A since Matt C’s last post? Should I be looking at doing it with LabView or something else?

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Most Active Software Boards: I am able to communicate with the device through the GPIB interface, and am also maunal to retrieve information.

Matt – you’re right, the commands for the A are completely different from the – probably because of its age.


Message 2 of 6. Message 3 of 6. In the code above, MHz is an arbitrary frequency. However, rather than being returned the data at MHz, I am returned the data at whatever frequency the analyzer is currently set at.

I have not worked with that instrument, but hp44191a Agilent web site has the operating and service manual here.

I went through the manual before, but when I saw their GPIB section, the strings were so convoluted and so unlike anything I’ve ever seen before that I assumed it was referring to something different. In particular, after setting up and manuap the instrument, I am initiating the measurement and reading it as follows: If not, what would creating a driver for it entail?

HP A for Sale|Impedance Analyzers|Impedance Measurement Products|Test Equipment Center

Message 6 of 6. Guess you never know until you try! Message 1 of 6. Thanks for your help guys. The forums emoticons took over for a bit there. Would you mind posting the code you used on the A? It’s 84MB, so I hope you have a fast link. I suspect that this difference might be causing my problems.


In particular, after setting up and initiating the instrument, I am initiating hp4191s measurement and reading it as follows:. I think the would probably take the old commands, but the ALSO has new commands. Sorry, that last line of code there is supposed to read: You really need the manual.


I have worked with the A and, as I recall, the commands are nothing like any other instrument I have seen. IIRC, the sweep parameters were something like maanual Message 5 of 6. Message 4 of 6. Accepted by topic author Matt C.

Good luck with it When I gave it a try, though, it worked fine.